Відео

actually 2016-2021.....2015 previous gen

Thanks for the Video. I installed a new Trim today on my VW Touareg 2013. Your Video helped me a lot :)

Simple Enough… Thank You😊

Ever since I fixed that axle seal I Denver added a whole bunch of fluid back in I only had putted one small bottle in them 6$ bottles the other day I checked the dust stick there was hardly anything on it like small tiny spec but I didn't know u need 4 bottles of it so ima go get 3 more today

I have a 2004 Acura TSX my release work and my fence are good but when I turn on my AC, my fans don’t spin can you help me?

Thank you

Thanks for the straight-to-the-point instruction. I will be using your tutorial with a 2008 Fit.

Love your videos! I have a question, I got the STP Air Filter SA12065 and it does not have those little clips. Does it matter in your opinion?

Very cool. Thank you. Clear and to the point.

For the hydrolock to happen your tolerances have to be so low that the calliper would likely lock just on the tolerances. The pressure on the calliper is high enough to push the grease out through the space between the pin and the channel. People saying the air trapped will prevent the calliper from moving are hilarious

Why not just by a bearing cradle too? Save alot of time and stress

I've changed both 02 sensors twice and replaced my cat and still am getting p0420 code on a 2011 Camry SE. No other codes.

Changed expansion valve, compressor and condenser. AC now cools when it's not 95° F outside. If it is sunny, in the 90s and in idling I'll be sweating in the car. If I drive, I'll be sweating a little less. It's only decent in the morning and the afternoon. I hate it.

Very good direction

is the same process as a 2006 honda crv?

thank you, brother!

Hey bro do you know if it would be the same with a 2015 acura tlx 2.4 ? I would really appreciate it if you can reply im having the same issues and do you have to program it? Thanks in advance

Can you use a rubber gasket instead of the bond sealer?

Was the wheel a lil stiff to turn prior to changing the o rings ?

Where’s the fuse for the driver side doors ?

Thank you so much. My AC was working when it felt like it. I changed the fuse and switched the relays and so far it’s been working every time I use it.

Very good info. But I have to admit your impatience with the AC control was making me scream at the screen. "JUST WAIT 10 SECONDS DUDE!"

What about for a 2021 subaru outback the but doesnt say anything about ac pump

Yesterday my a.c was working (meaning cold air was blowing out) this morning when I was leaving for work. The air was not as cold. But the a.c was working. Idk if I need to change air filter or something. Thanks for the video. I’m still a little confused idk. Probably over thinking. :/

How much is pcm. 1000$? Expensive repair

So proud of mr rb

I did the same thing and the clutch did not engage. I put a new relay in and the clutch didn't engage. Here is the kicker: It does engage every day after the engine is cold and run perfectly, blow ice cold A/C, for about 2-3 minutes and sometimes even during the drive. What now?

Thank you

Hey man, super weird question. In the canadian winter (0c or less) if I turn on heat, my HVAC turns OFF and my blower is set to MAX until my car heats up, then I can change my temps and blower to whatever I want. On the flip side, my freon is filled, relay and fuse are fine, but my compressor will NOT turn on. It is not locked up or anything. Could this be my thermostat?

Thank you Sir

1 ac. So you don’t need to replace the cat if the car is. Starting to. Shut off.

Hello, what's the exact part number?

Would the brake master cylinder have anything to do with this?

Doing a job for an accord 1.5 but can’t find the turbo anywhere looks like this one. But I look 2018 accord 1.5 turbocharger and the civic 1.5 turbo pulls up. Are they the same ?

I also did the same diagnosed yesterday. 0i have 2018 accord touring, and they told me to change the fuel injectors with feed pipe. But the dealership denied it . Can you please tell me what to do sir.

Simple my ass 2:30

I have a 2 year old Wrangler Jeep, with only 25K miles, and a couple of days ago, the ac started blowing hot air. I have to wait a couple of days to take it in, but the vehicle is still like new, to have a problem like that

Just changed mine, but the line that goes into the front of the air assembly box (perfect image at 1:15 of video) broke off right at the base of the assembly box. Any ideas how to replace that or use epoxy to seal it? Appreciate any help.

I came here to know how to put it back, it’s so hard to make it fit

Hey there bro hope all is well. I have a 2007 Toyota Matrix 1.8 stick shift. Its jus started to surge at idle then hesitate and jerk at low speeds while driving at operating temperature then it goes away after short while of driving no check engine light and no codes. What is your opinion on what it could be or what should i do to maybe help the issue?

What if you see oil on the coil/spark plug?

A body shop was quoting 240 for the part and 2 hours of labor for this job... lol

Hey thanks for the help really helpful video. Is it the same process for acura csx 2006.

He'll yeah great video bro straight to the point!!

I dud exactly all steps you did it, but on the last step turn on car and a/c, with the test light not comes on. What's the next step?? Replace whole compressor

I have a 2017 Toyota Camry and my AC went out a couple weeks ago it's just blowing in hot air 🥵 i made an appointment to get fixed I'm praying they don't charge me a arm and leg 🙏

Thank you very much!

I do this ever 30,000 miles so it doesn't give me issues. Thanks for the video.

Thanks, brother you made it look easy. 👌

Thank you so much. This video helped me to fix my light in under 15 minutes. Bless you.